Funny dating site intro lines
Funny dating site intro lines - 100 dating miami millionaire
Ball bearings or Pointers/Flat Disks determine action (not sides of a spinner) in small hand-held devices. Advertising put & takes (company name on spinner) 4. If it landed "0" or Put All or All Put, each player would contribute one chip to the pot. Put & Takes were usually about 1-1/8" long, weigh 16 grams and made of brass, like the three tops shown below.
The one on the near left has these sides: TA (take all), P3, T2, P1, AP (all put), T3, P2, T1.
Remember, 100% of your purchase fuels the fight for LGBTQ equality and makes you an active member of the Human Rights Campaign.
The top would pass to the next player after each spin. For example, "Put All" could mean that the spinner matches the pot! 6-sided tops, like the one at the left, are much more common than 8-sided ones.
The Dreidel (a four-sided spinner with Put & Take-like instructions on the sides) was developed in 16th century Germany. I sold a similar one on e Bay in July 2013 for .
They could be carried in ones pocket and used anytime in a bar, army barracks or other gathering place for an impromptu gambling session. He describes it as "in the form of a Bosch (Bosch-Lavalette) spark plug. It spins quite well virtually each time if you are careful. The sale was helped with this neat composite picture of many angles of the spinner. T: take from pot) P11222 If one P is rolled, the player rolls again or passes the dice to the next player, depending on the agreed rules.
Each player would contribute chips, coins or currency to a pot. So, for example, if "1P" and an "R" appeared, it would mean a pair of kings! As far as I could determine, originally from France and probably for the game Pinochle. One issue I have is that if you tighten the handle (as you normally would), the upper level presses against the lower level, so the upper level won't move independently. And here, which shows the company's lighter in the three upper pictures, and the other pictures are of the bi-level Put & Take made from some of the same parts. (Bosch-Lavalette was an old German-French partnership firm which made a wide variety of light engineering precision work, largely connected with fuel injection pumps and small electrical equipment, and large petrol engines. Similar to the one above -- made by the same person, modern, aluminum, 1-1/4," 12 grams. Near the handle, the patent number 33471 is engraved. Proudly made at the Crisloid factory in Providence, RI." Modern Put and Take dice. If two Ps are rolled, the player takes the entire pot (as in Take ALL). Made by Koplow Games Inc., Massachusetts, made in China. Die 1: 1 2 3 4 5 All Die 2: Put Take Put Take Put Take Rules are on the back of the container. Thanks, E." "Put & Take spinning top / Teetotum Wooden handmade, eigth sides 4,5cm long and 2,2cm diameter TA: take all T3: take three P1: Put one T2: Take two AP: All put P3: Put three T1: Take one P4: Put four Spin well, 40 seconds over glass surface" "New spinning top for Parta Ola (Put and Take), the traditional spinning top game.
I have found 1921 to be the earliest use of the term "Put & Take." The spread and popularity of Put & Takes was a true "craze," a term applied to Put & Takes even then. Lavalette, a French firm, and Bosch, a German firm, partnered between WW I and WW II.) Unusual bi-level top with 8 colored balls. This piece is in all original pre-owned condition age related wear and marks. Same as top #4 in the chart above, except one side is COLON, not COLIN. described it as, "Vintage 6 sided Bi-level "Odds On" Spinner, Circa 1920s. The top level sides are marked with the odds in this order: " E [Even], 2-1, 4-1, 5-1, 6-1, 8-1." The bottom level is marked with the symbols in this order: crown, heart, spade, anchor, diamond, club.. Looks to be made of brass with a silver coloured finish. The above three pictures show how a Put and Take can be rigged for cheating. One unusual rule: "If a PUT and an ALL are rolled, then the player puts in an amount equal to the entire pot." While unusual, I have seen this rule mentioned many times. Per seller: "The bidding is for ONE dice only, I have shown 2 in the photo to show more faces of the dice. This is my version of a game I loved as a child called "Put & Take". Hand lathed of aluminum, well balanced for long spins.And of course, there are virtual Put & Take aps where you can design your own game; here too. Now-a-days there are too many manifestations of Put & Takes games and rules to mention on this page, which is dedicated to vintage items. Here are some historical informative links on the subject of Put and Takes. Links to other Put & Take websites: Marianne Jager . 15 second video -- Self-made teetotum for kids; neat toy spinner. If it landed P1, P2 or P3, he would lose (put) 1, 2 or 3 of his chips, respectively, into the pot. Because the three discs spin separately, the final outcome is always completely random. April 2017, it went for almost 0 (plus shipping) on e Bay. The odds are 2 to 1 4 to1 5 to1 6 to1 8 to 1 and Disqualified. And as you would expect, on this top, all four of the Take sides are shaved on the bottom left, and on all four Put sides, all of the bottom rights are shaved. The case is replicated to look like a wicker basket. This patent pending design is precision balanced and the smooth rounded patent pending spin-tip will not mar surfaces. Each piece weighs in at a heft .3 ounces and provides enough weight to keep the die spinning for over two minutes if you'd like. The "secret" is somewhat similar to the three red celluloid Put & Takes near the top of this page: if a player (the mark) twists the top to the right (clockwise) --as most players would-- it will almost always land with the "Put" sides showing, and if the hustler, who knows the secret, twists the top to the left (counter-clockwise), the top invariably lands with the "Take" sides showing. Note the spellings of "Spinning Top" in different languages on the box. "made of: wood, tin package size: 15 cm x 8,5 cm x 8 cm weight: 0.15 kg suitable age: 6 Traditional board game. Per dealer: "This card game is a variation from the simple dice or top games designed to risk pieces of candy, coins or a few bucks.They also provide information on the letters (P, N, D, etc.) and initials (NG, ZS, TA, etc.) found on many, especially old, Put & Takes, teetotums, etc: Wikipedia Teetotum article . If it landed "0" or Put All or All Put, he would have to match the pot (the rule given in John Scarne's "Scarne on Dice.") or lose all his chips or each player would have to contribute to the pot, depending on the rules. Apparently the spinner was used to help simulate a baseball game -- no odds, no gambling use. Click here for an ad for a similar baseball top, also 1921. G -- 1= Ace - Ace A kings crown with an "R" under it -- R= Roi - King A queen's crown with a "D" under it - D= Dame - Queen Another type of hat with a "V" under it - V= Valet - Jack 10 diamonds" Note that it is over 1-1/2" tall. The teetotum measures 3.5cm tall." The spinner has to do with selecting and betting on sporting teams -- whether home or away team wins or there is a draw. Just the opposite would happen if you spin the same top counterclockwise or the top on the right clockwise. In his book "Scarne's New Complete Guide to Gambling," John Scarne describes this safer (for the cheats) method: two cheats start playing the game with a fair top in a bar or restaurant. When the action really gets going, one cheat switches a crooked top ("put" favored or "take" favored) in and out of the game as required. Half the time it does not spin; and the other half of the time it is a poor wobbly spin. Dealer masterpanus described it as "Put And Take Brass Teetotum Gambling Top Trench Art Replica -- Gambling teetotums hand made by me in San Diego, California. Each top I make is different since they are hand made. Seller says, "INCLUDED IN THIS SET ARE FOUR SETS OF DICE. The basket measures 2 1/2" long x 1 3/4" wide x 1 1/4" tall. Each are made of bone and feature black & red colored barrel shaped die & "Put & Take" spinning top piece. We've had seconds as our best spin." The large blue one (click here to see) is about 2" long and 1" wide. The red celluloid tops worked that way because the lower portion of the sides were rounded in such a way to force the desired outcome. Dealer said, "The contents of the game are the metal dreidel, 10 authentic Gold nugget replicas, rulebook with a very short history of the California gold rush, and a canvas pouch to hold it all. A., Original price tag from the Mel Fisher Museum of .95." note: I don't own this one. One collector reported to me that this top spins very poorly. Contents: 12 pieces coin , 1 spinning top,." Note: same chips as in the "Morgan's Revenge" set above. 54 cards contain instructions to put or take playing pieces with the pot or other players. The company makes many small metal machinist products like belt buckles, bottle openers, spinning tops, etc. I'd appreciate it if someone would tell me about the card game, how it is played, number of cards. It notes how some call "profit" a dirty word and want confiscatory taxes. Dealer described it as: "At auction today is a vintage Put and Take game of chance with a Birdseye Maple tray. Put & Takes -- Non-English language vintage Put & Takes (***this is a link to another page***) 4. Everything else: miscellaneous odd Put & Take-related items, but not spinners: bagatelles, pinball machines, playing cards, darts, spinning disks, etc. Rolling: Dice, faceted balls (vintage, not sterling), logs -- put and take-related 9.The commands on the six sides are usually in words. The commands are usually: take all, all put, take two, put one, take one, and put two.1921 Illustrated London News article -- a full page picture and article entitled "PUT AND TAKE CRAZE : A SUBSITUTE FOR PITCH AND TOSS." It says there that "Put and Take ... 1921 "Ripley's Believe or Not" column on current Put & Take rage -- it had some wrong historical information, but said, "Of course you play that new game of the spinning top called Put and Take? The dark one near the upper right is a cube-shaped metal Put and Take. The two at the lower right and lower left have internal spinning dials. Guaranteed old and original." Per seller: Vintage Bakelite Top ... The white and red parts are bakelite - The spin seperately from each other so the final outcome is always random - The blue handle is wood with some wear to the paint - The markings on the white part are P and T and on the red you have 0 1 4 A 2 3 "It is marked "Spinim" on top with a patent number. Thus, all the players could spin the top clockwise, but would get different results depending which way the spindle was pushed. Here the body of the apinner is not rounded on both ends (as described in the row above), nor is it rounded on even one end (as with the red tops above). Seller says: "As usual it has the following markings: Put One, Take One, Put Two, Take Two, Take All, All Put. He states in e Bay auction, "This listing is for the Classic six sided solid brass spinning top game Put and Take. These can be spun as tops on a smooth surface with a little practice, but are designed to have a short spin time to keep the game moving. ".00 plus shipping." There is also a deluxe edition in a tin box, for a little more money; click here to see it. Manufacturer: Dan Kroll Industries Corporation, Billings, Montana. Pend" (for patent pending) is etched on top of top near handle. the casino game with a message: 'what goes around comes around.'" Comes with: put and take spinner, 4 colors of plastic common chips, purple sachel bag, instruction sheet and original box. Seller in UK says, "Modern Copy of the 1930's Brass Put & Take Spinning Top Dice Gambling Game." On e Bay (March 2015) he starts auction at plus shipping to U. "T1" - Take 1: The spinner takes (gets paid) 1 from the pot. This unique 8-sided version adds excitement with each spin. This offensive was to become known officially as the First Battle of the Somme. THE POCKET GAMING COIN TUBE / VESTA MATCH SAFE & STRIKER COMES WITH THE SOLID BRASS SPINNER GAME. These spinners are hand machined by my husband (Jim) from solid brass stock. The letters and numbers are then hand stamped onto each of the 6 sides of the piece. Each spinner comes with a free spun aluminum storage container (color may vary) that can be attached to a keychain. " Sold by the maker, in Pueblo, Colorado, for .50. With a little practice it can also be spun UPSIDE DOWN!! The dimensions are approximately 30mm long and 15mm wide at widest point. I live on a bush property with a small solar power system and make the spinners myself. Also called vintage and listed many times by the same seller. The top of the machine says "Test Your Skill For." That is just an attempt to call it a non-gambling game, which would be illegal in most places at that time. Apparently you put the finger of one hand through the loop and quickly push down that yellow piece with the other hand, and the blue piece is pushed out spinning. Patrick Molloy." June 2017, I paid plus postage for a boxed one on e Bay. I don't know why the store was named "Put & Take." The owner of the chip thinks it was a "general merchandise and clothing" store. If you spin the top and it gets close to the edge, it does NOT immediately tumble and stop -- rather, it just moves away from the edge and continues spinning, for the most part, and then it collapses and stops. You press down on the little red knob at the lower righrt to get the two "rotors" (wheels) to spin -- the "number rotor" (numbers 1, 2, 3, 4, and 5) and the "color rotor" (put, take and take all).